 |
|
|
Roofing Basics
Roof Problems:Warning Signs
| The following will help you identify the
potential for roof failure. |
 |
|
BARE SPOTS
|
|
 |
The protective granular surface of shingles wears
off as the asphalt, into which the granules are embedded, begins to harden over
time. Bare spots are often accompanied by fine fissures on the shingles'
surface and by the accumulation of granules in the gutters.
|
|
|
CURLING
|
|
 |
The upward curling of shingle tabs makes them
highly susceptible to wind and ice damage. This is a problem on older roofs
where moisture build-up in the attic affects the underside of the shingle.
|
|
|
BROKEN SHINGLES
|
|
 |
Damage can be caused by extreme wind conditions and snow removal. Since shingles are supposed to shed water, broken, torn or missing tabs become obvious entry points for water, especially on low slope roofs where run-off is slower and at the peaks of the roof where shingles are the most vulnerable to high winds. |
|
|
CLAWING
|
|
 |
This is the curling under of the shingle tab's bottom edge and is part of the normal aging process of shingles. The bulge created is susceptible to substantial damage by wind action, hail and ice.
|
|
|
BUCKLING
|
|
 |
Buckling is a visible distortion or waviness in the
horizontal lines of shingles, and usually runs in a straight line up the roof
slope. Shingle tabs become exposed to wind and can be torn off. Very often, the
problem is warping in the roof deck caused by poor attic ventilation. The use
of thinner-than-recommended plywoods and other non-plywood materials adds to
the problem.
|
|
|
FLASHING
|
|
 |
Many problems occur at the flashings around vents,
soil stacks, chimneys and vertical wall joints. Is the flashing cracked? Is the
caulking around the flashing dried out? Are the shingles that lie over the
flashing in good shape?
|
|
|
|
|
|
